9.801-
296.0•Shark•Rev.11/12
OPERA
T
OR’S MANU
AL
PRESSURE
W
ASHER
10
COLD
WATER
INLET
COLD
WATER
OUTLET
INSTRUCTIONS
0°
40°
40°
25°
WARNING
PRECAUTIO
N
ATTE
NTIO
INSTRUCCI
ONE
15°
ON
PRENDE
R
OFF
I
O
E
BE
LT
PR
98012960-12
SHUTDOWN PROCEDURES
STEP 1:
Rinse all lines (and in-
jector) with clean water, to remove
any soap residue then turn toggle
switch off.
STEP 2:
Turn off water supply.
STEP 3:
Open spray gun to relieve
remaining pressure and remove
water supply hose.
In freezing conditions, disconnect
water supply and open spray gun
to allow water to drain, then turn
off motor.
CAUTION: Do not allow pump to
run longer than 5 minutes without
water. Disconnect all hoses to al-
low water to drain.
CAUTION: With machine off, open
spray gun to release pressure be-
fore removing discharge hose.
STORAGE
CAUTION
Pump Storage
CAUTION: Always store your pres-
sure washer in a location where the
temperature will not fall below 32° F
(0° C). The pump in this machine is
susceptible to permanent damage
if frozen.
F R E E Z E DA M AG E I S N OT C OV E R E D B Y
WARRANTY.
If you must store your pressure washer in a location
where the temperature is below 32° F, you can minimize
the chance of damage to your machine by draining your
machine as follows:
1. Stop the pressure washer and detach supply hose
and high pressure hose. Squeeze the trigger of the
spray gun to drain all water from the wand and
hose.
2. Restart pressure washer and let it run briefly (about
5 seconds) until water no longer discharges from
the high pressure outlet.
Toggle
Switch
98012960-17
98012960-18
