Pull each canopy section out to the position where you want it to
end. Place a
Top Lock Bracket
on the top of the track in the
orientation shown in Fig. 2A. Tighten set screw 1 on both sides of
the
Top Lock Brackets
with the Allen wrench provided (I) . . .
making sure that the
Top Lock Brackets
are completely pushed
down on the track before tightening.
Test the snap-in
Top Lock Bracket
and tighten or loosen the
adjusting screws as required for the desired tension. The
recommended tension setting procedure is to turn the adjust
screw clockwise until it stops, and then back the adjust screw out
six full revolutions Repeat this step on each lock mechanism.
Step 17
Installing the
Top Lock Brackets
Pull each canopy back to the fully retracted position. Place
another
Top Lock Bracket
on each track at this point, in the
orientation shown in Fig. 2A. Tighten the set screws.
NOTE:
The locking system is designed to release the canopies in
high winds to protect the canopies. The adjusting screws can be
used to adjust the tension. Do not over-tighten, as this could
increase the chance for canopy damage in high winds.
Step 18
Assemble
Screw Caps
Locate the small white Caps (E) in the hardware packet and
snap the caps onto the screw cap washers (D).
Adjusting
screws
Stop
Stop set
screw
Set
screw 1
To p
osts
To h
ous
e
FIG 2-A
Step 19
Adjusting the
handle height
(optional)
Each canopy has the handle overhang approximately 18” from
the tracks. This drop handle is for opening and closing the
canopies. However, if you must have less than an 18” overhang,
follow the instructions below for shortening the handle
height.
1. Remove all screws in the handle and open the
handle the entire width.
2. Cut the fabric to the desired length.
3. Carefully close the handle and re-insert the screws
provided - do not overtighten.
4. Reinstall the top caps in the end of the handle.
ShadeTree
®
Canopy Systems
Assembly Instructions
The Greenbriar
ShadeTree Cool Living, LLC
— For questions or assistance call
800-894-3801
.
9
