shada 240120 Series, Operating Manual

Page: 8 / 24

8
18 Problems and solutions
- Detection range settings (sensitivity)
Detection range is the radius of the circular detection zone after mounting the
sensor at a height of 2,5m. Turn the detection control fully anticlockwise to select
minimum detection range (approx. 1m radius), and fully clockwise to select maxi-
mum detection range (approx. 8m radius).
Note: The HF sensor scanning specifications may vary slightly depending on the
mounting height and location.
Attention: When using this product, please do not adjust the sensitivity to ma-
ximum. Factors like blowing leaves or small animals can cause the product to turn on. If the
product does not function properly, please lower the sensitivity settings.
- Timer settings
The light can be set to stay on for any period of time between 10 seconds (dial
turned fully anti-clockwise) and a maximum of 30 minutes (dial turned fully
clockwise). Any movement detected during the “on” time will reset the timer. The
LED indicator will flash when adjusting the time setting dial. The number of flas-
hes means the following:
1 flash = 10 seconds, 2 flashes = 1 minute, 3 flashes = 2 minutes, 4 flashed = 5 minutes, 5
flashed = 8 minutes, 6 flashes = 10 minutes, 7 flashes = 15 minutes, 8 flashes = 20 minutes, 9
flashes = 25 minutes, 10 flashes = 30 minutes
- Light control settings
The chosen light response threshold can be anywhere between 10-2000 lux. Turn
the dial anti-clockwise to select dusk to dawn operation at 10 lux. Turn the dial
fully clockwise to select daylight operation at 2000 lux. The dial must be turned
fully clockwise when adjusting and testing the detection zone.
Note: please do not adjust the three dials past their maximum, as this will dama-
ge the product.
TIME SENS LUX
TIME SENS LUX
The light does not switch on
Wrong light-control setting
selected
Check and adjust settings
Broken light Change light
Main switch is OFF Switch ON
The light is on all the time
Continuous movement in
the detection zone
Check zone setting
The light will go on without
any visible movement
The sensor is not mounted
for detecting movement
reliably
Securely mount the sensor
TIME SENS LUX