PAGE 5
LOADING THE TOOL
Connect the air hose.
Depress the magazine latch. Pull back on the magazine cover.
Insert a stick of fasteners into the magazine. Make sure the pointed ends of
the fasteners are loaded with the points downward. Also make sure fasten-
ers are not dirty or damaged.
Push the magazine cover forward until the latch catches.
OPERATING THE TOOL
Add a few drops of tool oil
Attach a high flow quick connector fitting to the tool. Empty the magazine.
Regulate the air pressure to obtain air pressure within the working pressure
range at the tool.
Load fasteners into your tool following the instructions in this manual.
Test for proper fastener penetration by driving nails into a sample piece of
wood. If the fasteners do not achieve the desired penetration, adjust the
air pressure to a higher setting until the desired penetration is achieved. If
you are using a tool with a depth control device, turn the thumb wheel to
achieve the desired penetration.
