SGM G-1 BEAM, User Manual

Page: 25 / 32

25
Installation and rigging the G-1 Beam POI
While the base of the standard products include 1/4 turn fasteners camlocks for omega brackets, the base of POI products come
with M-10 nuts for M-10 screws. The M-10 screws are included in the package in the same amount as the number of M-10 nuts of
the base.
The G-1 Beam POI has two M-10 nuts in the base that can be used for installation and rigging. The SGM Omega bracket (not
included) or a customized bracket is needed to install the fixture. Consider the dimensions below of the G-1 Beam POI base for
customized mounting brackets purposes.
The SGM POI Omega bracket suited for M-10 holes can be ordered as an accessory. Contact your local SGM dealer for further
information on correct POI rated mounting.
Figure 25: G-1 Beam POI base with dimensions
LED Indicator
An LED indicator is located on the side of the yoke, and shows the current status of the fixture.
The LED indicator has two different colors and three possible stages: static, flashing, or off.
• Static green: fixture is powered and receiving DMX signal.
• Flashing green: fixture is powered on without receiving DMX signal.
• Static/flashing red: an error message is stored; review via the SGM RDM Addressing Tool,
reboot the fixture, or contact SGM support for diagnostic help.
• Off: fixture is off or indicator LED is set to off or auto dimming (set via RDM).
Connecting DMX and AC power in POI
DMX in and DMX out are in the same cable (see figure 27), and the power is
wired as the standard version. See “Connecting AC power” on page 9.
For permanent installations, have a qualified electrician wire the mains cable
directly to a suitable branch circuit. The junction’s ingress protection (IP) rating
must be suitable for the location.
For a temporary installation, the mains cable may be fitted with a grounded con -
nector intended for exterior use.
PLEASE NOTE!!
• Standard microphone cable are not suitable for transmitting DMX.
• Up to 32 fixtures can be on the same DMX link. Additional fixtures
will overload the link.
• The last fixture must always be fitted with a DMX termination plug
to the fixtures DMX out.
• SGM fixtures provide a passive DMX Thru signal as DMX Out,
instead of an active output signal.
SGM SGM SG
Shield
Wire Color
White
Red
Conductor
Black
Yellow
Ground
DMX IN: Data -
DMX IN: Data +
DMX OUT: Data -
DMX OUT: Data +
SGM POI DMX Cable
Figure 27 : SGM POI DMX Cable
G-1 Wash POI
A
A: Power in
B: Bracket for base mouting (POI n/a)
C:
Display panel (POI n/a)
D: Yoke handles
E: G-1 Wash front lens
F:
Power indicator
G: DMX in and out
H: Safety wire attachment point
I: Holes for Omega bracket / M-10 screws (x2)
J: LED indicator (POI only)
C
B
D
I
E
J
H
F
G
Figure 26 : POI LED indicator