SGM
GB
Fogger 1000 - Fogger 1500
5
Adapte and Nut must be tightly connected
Assemble 2 washers in both inner sides of the
mounting bracket with fixation screws on the
outer sides
Note:
A fluid level sensor is installed on the unit. The machine will stop to fog if the fluid is lower than
usable level.
If you experience low output, pump noise or no output at all, unplug immediately. Check fluid level, the
external fuse, remote control connection and power from the wall. If all of the above appears to be O.K.,
plug the unit again. If fog does not come out after holding the remote button down for 30 seconds, check
the hose attached to the tank to make sure there is fluid going through the hose. If you are unable to
determine the cause of the problem, do not simply continue pushing the remote button, as this may
damage the unit. Return the machine to your SGM dealer.
6
T
ECHNICAL
S
PECIFICATIONS
Model
FOGGER 1500
FOGGER 1000
Power Supply
AC100V - AC120V - AC230V - AC240V, 50Hz-60Hz
Power Consumption
1,500 W
1,000 W
Output Volume
600 m³/min.
300 m³/min.
Tank Capacity
6 liters
2.4 liters
Fluid Consumption
8,5 min./ liter
13 min./ liter
Weight
15 kg
9.8 kg
Dimensions (LxWxH)
552 x 230 x 155 mm
370 x 295 x 135 mm
Remote Included
Z-10
Z-10
Optional Remote
Z-40, Z-50
Z-40, Z-50
Warm-up Time
8.5 min.
10 min.
7
R
EMOTE
C
ONTROL
O
PERATION
Z-10: 10 meter wired remote controller with 6,3 mm jack plug of SGM fog machine models Fogger
1000 and Fogger 1500. The red lamp indicates that the unit is receiving power. When the fog
machine has reached operating temperature the green light on this remote control will light up,
indicating that the operator may begin fog emission by pressing the red button. The green light
flashes during fog machine warm-up and re-heating cycles (approx. 1-2 minutes), and stays ON
when the machine becomes operational. The Z-10 features the “toggle switch’’ function: press once
for continuous “on”, press again to release continuous “on” function
Z-40: 10 meter wired remote controller with 6,3 mm jack plug for SGM fog machine models Fogger
1000 and Fogger 1500. Its two knobs allow the operator to customize fog machine functions by
adjusting output duration and interval. Press the yellow TIMER-button to activate the timer function.
Adjust the interval between each fog emission (within the range of 1 second to 250 seconds) by
means of the INTERVAL control knob. Adjust the duration of each fog emission (within the range of 1
to 15 seconds) by means of the DURATION control knob. When pressed, the green FOG button
Tank Kap
PU Tube
Filter
Tank
Mounting Bracket
Fixation Screw
Fixation Screw
Washer
Washer
www.audiovias.com
