Hardware Setup
STRATO PI CM CONNECTION DIAGRAM
For the initial set-up, the plastic DIN rail must be removed to access the circuit boards and
internal connectors.
The case also needs to be opened if the factory configuration of the RS-485 termination
resistors must be changed (see below).
Before opening the Strato Pi CM case, disconnect all power sources and any connection
to external devices, including USB and Ethernet cables.
Opening the case
Follow these steps, in the exact order, to open the case:
1. Remove the green pluggable terminal block
2. Remove the black plastic DIN rail hook
3. With a small flat screwdriver gently separate the bottom case and boards assembly
from the top cover; lift the side next to the DIN rail hook first
4. The circuit boards assembly will simply slide out of the case, as it is mechanically held
in place by the bottom case only
NOTICE
10
Strato Pi CM User Guide
