36
GB
10. Re-install the grill insert after cleaning. Ensure that
•
the protrusion on the grill insert engages into the corresponding
recess in the housing (fig. 9),
• the insert is pushed down all the way and correctly seated (fig. 9).
Fig. 9:
Fitting the grill insert correctly
9.3 After use: cleaning the interior
After use, and also if the appliance is not going to be used for some time, we
recommend opening the cleaning flap and thoroughly cleaning the interior of
the appliance.
WARNING!
If the interior components are not cleaned on a suf-
ficiently frequent basis, there is a hygienic risk, and
the fire danger increases; in addition, it will become
more and more difficult to remove old dirt particles.
– The interior components should therefore be
cleaned regularly, and also each time the unit is
not going to be used for some time.
1. Disconnect the unit from the mains.
2.
Wait for around 30 minutes until the interior components, including the
fat tray, have cooled down to room temperature.
Fig. 10:
(a) Remove the sausage holder (b) Fit the sausage holder
3. Loosen the screw on the cleaning flap.
4. Open the cleaning flap and take it off.
5. Remove the sausage holder (fig.10 a) as follows: hold the slide control
in place and lift up the upper corner of the sausage holder. The holder
can now be taken out.
6.
Clean the sausage holder with a sponge and a little detergent, or in the
dishwasher.
7. Wipe clean with a dry, lint-free cloth afterwards.
8. Close the cleaning flap.
WT5005_CS6VM_EN.indd 36
21.08.2020 11:01:18
