Fino Multi KA4566
10
Adjusting the beverage quantity
The beverage quantity for fi lter coff ee can be adjusted and saved in 5
interval steps
(also see table in section „3.4
Beverage quantity, brewing
temperature and steep time – overview“).
1. Insert the strainer support for fi lter coff ee into the appliance as
described above.
2. Press and hold the Start/Stop button (H.5)
until the display
elements (H.1)
and (H.4) light up.
3. Through repeated short pressing of the Start/Stop button (H.5)
you
can increase the beverage quantity by one interval step, respectively. If
the maximum beverage quantity has been reached and you press the
button again, setting starts again with the fi rst interval step.
4. When you have reached the desired setting, press and hold the Start/
Stop button (H.5)
until the display elements (H.1)
and (H.4)
extinguish. Now the setting is saved.
!
Note: If no button is pressed within 30 seconds, the settings are not
changed and the programme returns to stand-by mode.
3.2 Coff ee pads
1. Place a coff ee pad into the centre of strainer support (C).
!
Note: Only use commercially available round soft coff ee pads. If the coff ee
pad is slightly bulged on one side, place the pad into the strainer support
with the bulged side facing downwards. Never fi ll coff ee powder into the
strainer support for coff ee pads.
2. Now open brewing unit (A). For this purpose, fully fold open the
bracket closure (B) and insert the strainer support. When inserting the
components into the brewing unit (A), make sure the paper edge of the
coff ee pad is not placed below the gasket.
3. Close the brewing unit (A) by fi rmly pressing the bracket closure (B)
downwards.
4. Place a suitable coff ee cup onto the drainage grille (G).
5. Press the Start/Stop button (H.5)
. The brewing process is started
(cup symbol fl ashing (H.1)
). After a short heat-up phase the cup
is fi lled with coff ee. Progress is displayed by means of the interval
indication
.
6. Please wait until your appliance has completed the follow-up time, i.e.
the display element (H.1)
stops fl ashing. A short acoustic signal is
generated.
C