1.
Safety instructions
Please read the operating manual carefully before you start with commissioning.
Consider the
following warnings to avoid personnel injuries and machinery failures. SEVA-tec GmbH
assumes no responsibility or guarantee for damage and consequential damage caused by failure
to observe the operating instructions.
1.1.
Validity
These operating instructions are only valid for the following low-voltage three-phase motors
(for AC motors, brakemotors, motors with frequency inverters and ATEX motors
there are special operating and maintenance instructions from SEVA-tec):
Series: MS, MX, MX2, MX3, ML, KSD, KSE
1.2.
Qualification of the personnel
All work on transport, connection for commissioning, and regular maintenance must be conducted
by suitable, qualified, instructed, and authorised personnel. (VDE 0105: please observe IEC 364).
1.3.
Basic safety rules
The safety risks posed by the motor must be reassessed after installing it into the end device.
The
local occupational safety regulations must be observed during the usage of the motor. The
operation place must be kept clean and tidy.
1.4.
Electric Voltage
Regularly check the electrical equipment of the motor.
Immediately replace loose connections and
defected cables. To avoid electrical shock, use a rubber mat while working on the electrically
charged motor.
DANGER
Electric charge on the motor
Do not open the terminal box until five minutes after the voltage supply has been switched off.
DANGER
Voltage can occur at the terminals even when the motor is switched off
Do not stay in the danger zone of the motor. When working on the motor, switch off the mains
voltage and secure it against being switched on again.
SEVA-tec GmbH - Lether Gerwerbestrasse 10 - 26197 Ahlhorn - www.seva-tec.de
3
