SETBus Electronic Destination Sign, Operation And Instruction Manual, Page: 99 / 171

ADDRESS LOCATION OF INSTALLATION
1 Front Upper
2 - 5 Main Side
3 Rear
4 Front Auxiliary
6 - 7 Auxiliaries
8 - 9 Side Auxiliary 2
10 - 11 Side Auxiliary 3
12 - 13 Side Auxiliary 4
14 Main internal
15 Internal Auxiliary 1
16 Auxiliary 2
All destination sign that leave the factory are
programmed according to the table next door but
can also be reprogrammed via the Control Unit. This
procedure is on page 27 "Change of Address"
When programmed into the software at the time of
creation or editing, the text appears in each
corresponding destination sign.
When connecting two information are presented,
(RV) software version and (SB) the address of the
itinerary, these information appear before the
programmed texts.
If that address has not been scripted, nothing will
appear in the destination signs and will be indicated
with 4 LEDs block, blinking in the bottom right of the
destination sign.
Note that only the programmed writings will be
shown at that address, so everything begins with the
control panel software.
Destination sign address
111