Wing assembly and adjustment
Carriage assembly
Fasten the carriages to the wings according to the quotas found in the following diagram (
Fig.15)
.
The quotas indicated in
Fig.15 A
and
B
are applied to wings
seen from the inspection side (cover) of automatism.
The
Fig.15 B
is valid only for automatism with only 1 wing shorter
than 780 mm, with right or left opening and with electric lock. For
all remaining cases (two wings or 1 wings wiith right or left openi-
ning) is refer to
Fig.15 A
.
NOTE
: for wings with antipanic break away system or only glass
wing you have to follow the assembling quotas you may find in
manual’s instructions of those accessories.
Use M8 hexagon head cap screws with flat and notched washers
(
Fig.16
part.
A
).
Wing assembly
Make sure that the anti-derailment device is completely low-
ered by unscrewing the M6 nut (Fig.17, C) and pushing the
indicated wheel downwards (
Fig.17
Part.
C
).
Lift the wing and position the carriages on the sliding rail
paying attention not to damage the rail.
Wing adjustment
Wing adjustment can be made distinctly on three axes based
on installation requirements (
Fig.18).
Cross adjustment (Po axis)
Adjust wing position
Fig.16
arrow
D
loosening bolts M8 (
Fig.16
part.
A)
and aligning them to the automatism support sur-
face.
Before tightening bolts
A
, carefully check that the carriage wheel vertical surface (that coincides with the carriage vertical
surface) is parallel to the box (
Fig.18
).
10
Installation Instruction
LIGHT MILLENNIUM
Fig. 17
Fig. 16
Fig. 15
Summary of Contents for LIGHT MILLENIUM
Page 1: ...Automatisms for sliding doors I N S T A L L A T I O N I N S T R U C T I O N...
Page 2: ...2...
Page 23: ...23...
