52
Troubleshooting
The radio doesn’t start?
Check the battery and recharge if neces-
sary. Make sure the radio is switched off
while charging.
The servos in the model don’t react?
Press the red button [Model] and check if
the model is displayed. If it is not visible
check the receiver voltage in the model and
the jumper of the receiver.
If it is displayed activate it with your radio. If
the servos still don’t react check if the servo
channels are assigned to a control.
See
chapter Quick Start
You changed control settings but the
changes don’t have the affect you
thought they would?
Check in the control menu if the same servo
channel is assigned more than once to one
control. Delete the multiple assignments.
Multiswitch decoder or multiswitch light
set don’t work correctly?
Remember that after activating a multi-
switch on channel 7 or 8 the receiver needs
to be bound again.
See chapter Menu
Receiver
Some decoder and light sets only check the
signals after switching the model on. Make
sure to replug the receiver channels only
when the model is turned off if necessary.
If you adjust settings in the multiswitch
menu always switch the model off and on
again afterwards.
The receiver doesn’t bind?
For binding the jumper of the receiver needs
to be removed or replugged. See the
manual of your receiver for details.
The servos on channel 7 or 8 twitch or
don’t react like they should?
Check in the multiswitch menu if the multi-
switch function is activated accidentally.
24. Troubleshooting
The connected speed controller with
teaching function doesn’t react like it
should?
For speed controllers with (automatic)
teaching function you need to make sure
that a control is assigned to the channel
where the speed controller is connected.
After switching on the radio shows “Cali-
bration values could not be loaded!
Please recalibrate.”
This note is shown if the 3D joystick setting
(active or deactivated) was changed without
calibrating the joysticks afterwards.
First check if the setting [3D stick] is right,
see [Menu] > [Radio] > [3D Stick]. If the
setting fits you need to calibrate the sticks
again. Please see the 3D joystick manual for
details.