Servomex DF-310E, Operator'S Manual

Page: 107 / 130

Troubleshooting and Calibration DF-310E 103
9.5 Shipping
If it comes necessary to return the analyzer to the factory or ship it to
another location, please follow the packaging and shipping procedure
below in order to prevent damage to the analyzer during shipment.
CAUTION
Do not ship the analyzer with electrolyte - thoroughly drain and
rinse sensor before shipping
Note: If you are returning the analyzer to the factory, first call
Servomex to obtain
a Return Material Authorization number (see
complete details below), then proceed as follows:
1. Turn off and disconnect the power source from the analyzer.
2. Disconnect all external electrical connections (alarms, data
output, etc.).Mark each for re-attachment later.
3. Remove the sensor as described on page 14.
a. Drain the electrolyte into a receptacle suitable for
proper disposal.
b. Rinse the sensor with distilled water at least three times.
Drain the water into the receptacle.
c. Securely hand tighten the cover.
4. Reinstall the sensor using the two sensor mounting screws.
5. Install the bulkhead lock nut. Cap the inlet fitting to prevent
debris from entering.
6. Put the analyzer in its original container. Ensure that all
internal components are adequately secured. It is recommended
that bubble packing or similar protective material be added
inside the container for added protection.
If you are returning the analyzer to the factory, contact the local
Servomex Business Center to obtain a
Return Material
Authorization number . Clearly mark the Return Material
Authorization number on the outside of the shipping container and on
the packing list. The analyzer must be returned freight prepaid.