GAS SECTION
9
GAS INSTALLATION
IMPORTANT NOTE
The factory default gas adjustment of this appliance is written in the rating label,
lacated below the appliance. For the gas type that is used in your home, contact
the nearest authorised gas dealer.
INSTALLATION & SERVICE REGULA TIONS
It is a legal requirement that all gas appliances are Installed & Serviced by a
competent person in accordance with the current editions of the following
Standards & Regulations or those regulations appropriate to the geographical
region in which they are to be installed:
• Gas Safety (Installation & Use)Regulations
• Building Regulations
• National Standards
• Regulations for Electrical Installation
Installation and service of any gas product must be made by a suitably qualified
person competent on the type of product being installed or serviced and holding
a valid certificate of competence for the work being carried out.
GAS CONNECTION
The installation of the gas hob to Natural Gas or LP Gas must be carried out by
a qualified installer. Installers shall take due account of the provisions of the
relevant National Standards Code of Practice, the Gas Safety Regulations and
the Building Standards.
For connect operation of the appliance, refer to the rating label to see which
kind of gas this appliance operates with.
Gas Connection to Non-flexible Pipe
(copper or steel)
Connection to the gas source must be done in such a way as to not create any
stress points at any part of the appliance. The appliance is fitted with an adjustable,
"L" shaped connector and a gasket for the attachment to the gas supply. Should
this connector have to be turned, the gasket must be replaced (supplied with the
appliance). The gas feed connector to the appliance is a threaded, male 1/2"
connector for round gas pipe.
Notes:
