13
RIGHT
side of the IR remote controller to set it as the unit controller ID.
For example, press the number
4
(right)
. This sets the unit IR remote controller ID as 4. To set the
unit IR remote controller ID as 15, press the number
x10
and then
5
(right)
on the right side of the
controller.
The idle time out is 10 sec.
NOTE:
If the controller ID set-up is needed for more than one unit, follow above Steps 1 to 5 with other units.
To reset ID
, follow
Step 1
to
Step 4
but
Step 5
IMMEDIATELY (within a second or two) press VIDEO of IR remote controller.
4-2. ID Operation via IR Remote Controller
Each unit will respond to the same signal from the IR remote controller whenever the units are powered up. To
prevent the above case, after numbering the unit, users need to press and hold “
SHIFT”
and then press
ID
(n)
on the IR remote controller first. Afterwards, this unit will beep once. It means this unit is ready to accept the
oncoming commands via the IR remote controller.
Tip: SHIFT +
n
( *
n
represents the
RIGHT
numeric keys in light grey area)
NOTE:
Because all units assume their IDs are active after re-powering up, the user needs to press
“SHIFT” + ID
again to give commands to a certain unit.
