Serpent Spyder MT2, Instruction Manual

Page: 3 / 20

sAfeTy mATTeRs
All instructions in this manual must be followed to ensure safe use of the car. This model is not
intended for use by children under 14 years .
Important pre-cautions
● Only run the car is designated areas or areas with very few people, so no-one can get hurt.
●
The car has a lot of power and the turning parts on the car can cause damage, also some
parts of the car like transmisison and motorparts can become very hot. So wear protective
clothing both as driver and helper and be carefull when picking up the car.
● Do not operate the car under dark conditions, as both you and others may not see the car
properly and can get hurt, due to lack of car control.
● Use good common sense while operating the car so you can fully enjoy your car.
Battery and battery-charging
● The battery and battery-charger are not included with this model. We advice to use good
quality NimH or Lipo rechargebale battery-packs with 4000 mA or more. Check carefully to
buy batteries with the correct connector for the speedcontroller, or also purchase and mount
other fitting ones.
● Use proper battery-charger specifically designed for that type batteries and follow the
instructions of the battery supplier and the charger correctly.
● Keep the battery and charger always in dry places only and never leave un-attended during
charging.
● When the batteries are at their end of life, dispose them at a recycling-place, check www.
call2recycle.org for more info.
QUICk-sTART
The quick-start section is not a replacement for the full instructions. To be able to use the model
to its best take the time to read the full manual.
1. Read the manual and safety pre-cautions ( page 3)
2.
Buy and install the batteries in the transmitter ( see Transmitter manual)
3.
Install battery packs in the model, make sure the speedo is switched off, connect the
cables (avoid reversed polarity) and securely fasten the battery-pack.
4.
Turn on the transmitter (see Transmitter manual). Always turn on the transmitter first
before to switch on the car and only turn off the transmitter after you switched off the car.
5. Check servo operation. Check that the servo works correctly and check that the car runs
straight in neutral position, trim as neededPerform a range test with the radio system
6. Personalise the body of your car by applying more decals if required.
7. Drive your modelcar.
8. Maintain your modelcar (page 9)