Serpent Pool Cleaning System Operating Instructions Manual Download Page 6

Page: 6 / 6

IN-POOL INSTALLATION

4. Adjust your valve(s) to allow for proper suction to cleaner if you are plugging

the cleaner into the wall.

TROUBLESHOOTING TIP: If your cleaner is not covering the whole pool, stays in

one area, or does not clean well enough, adjust your valves.

5. If you are using the skimmer, then install the automatic regulator valve by

placing it into the skimmer intake port and then installing the hose into the

automatic regulator valve. Also place the hose protector over the hose where the

hose will meet the side of the pool at the skimmer opening.

TROUBLESHOOTING TIP: If your cleaner stays at the surface or pulls in air from

the surface, install or check the automatic regulator valve.

6. Attach the hose to the cleaner’s top, lower the cleaner into the pool, feeding

the hose in slowly into the pool so that it can fill with water, and attach the

female end to the intake valve. Make sure there is not excessive air in the

hose. Turn the pump on and make sure the system runs smoothly.

7. OPTIONAL: If cleaner is getting stuck in one area of the pool, install the

eyeball diverter over your pool’s return line. Snap the outer washer ring over

the eyeball diverter before screwing your pool’s retaining ring over the washer

ring and eyeball diverter.

TROUBLESHOOTING TIP:

If the return line pushes the cleaner away from that

area of the pool, adjust or install the eyeball diverter.

Summary of Contents for Pool Cleaning System






