IN-POOL INSTALLATION
IN-POOL INSTALLATION
In-Pool Installation:
1. Make sure the pool is generally clean, free from debris, and the entire pump
and filtration system is clean. Empty your skimmer and pump baskets.
TROUBLESHOOTING TIP: If your cleaner does not have enough power, stays in
one area, or does not move at all, clean the pump and filtration system.
2. Assemble the hose pieces together.
Determine the proper amount of hoses
needed. Start at where cleaner is hooked into the wall or skimmer then go to
farthest point of pool and
add one extra section
. The female/female end should
be at the end where the hose will attach to the intake of the pool.
TROUBLESHOOTING TIP: If one area of your pool is not being cleaned, your hose
may not be long enough.
3. Place hose weights on the hose.
You will need
one hose weight if your pool
depth is less than 6 feet, two if the pool depth is between 6-9 ft.
TROUBLESHOOTING TIP: With correct hose weights, your cleaner should sit
at a 45 degree angle on the bottom of the pool. If your cleaner isn’t working
correctly, the hose is sinking, or the cleaner is stuck in one area, adjust the
hose weights’ location, or add/decrease the number of hose weights.
7
8
