www.SereneLifeHome.com
5
•
Notice:
The factory set pressure value of the air pump is 10PSI (10PSI=0.689BAR),
and at the time of the secondary use, the set pressure value for the last time use
will be displayed by default.
•
Notice:
After powered on, if there is no operation within 2 minutes, the air
pump will enter standby mode, and the machine can be initiated by pressing
the power switch button
VI. PRECAUTIONS
•
The applied power source must be the 12V DC power source (as Figure 3).
•
Don't block the air inlet (10) at the bottom of the air pump, and guarantee air
inlet (10) to be always unblocked.
•
Observe the local waste treatment provisions, and it is not allowed to throw the
air pump away randomly.
•
Don't use this product when the hose is damaged, and please change the hose
immediately.
•
Don't pull out the hose when inflating, because that the high pressure may hurt
the physical body.
•
Don't make the air pump work for more than 20 minutes, because that motor
overheating may cause internal damage; and the air pump shall be fully cooled
for 30 minutes after continuously working up to 20 minutes.
•
Please don't use this air pump if any part is damaged, and please contact with
the professional personnel to repair it.
•
This product shall not be exposed to the rain or immersed in water.
•
In order to prevent risk, the inflation inlet shall not be forward to face or body.
•
Please don't not leave while inflating.
•
Please start the car when using the product, in case of unnecessary damage.
www.SereneLifeHome.com
6
VII. FAULT HANDLING
VIII. MAINTENANCE AND STORAGE
•
After using, or if you want to move, maintain or adjust the product, please first
pull out the DC plug from the socket.
•
When it is idle, it shall be properly stored after being fully cooled.
•
It shall not be exposed to the rain or immersed in water.
•
Please store it in the dry and ventilated place.
Figure 3
Fault
Inspection
Solution
The air pump
cannot be started
normally.
1. The power source
is not plugged
properly.
2. The fuse in DC
plug (7) is burnt
out.
3. Overheating or
overload causes
motor stop.
1. Make sure that the power
wire is plugged in the 12V
DC socket.
2. Change the fuse.
3. Cool the motor and restart it.
4. If the problem cannot be
solved, please contact with
the manufacturer or its
service agent or the similar
authorized personnel.
Slow or abnormal
inflation.
1. Check whether
the hose is blocked
or cracked.
2. The joint between
the hose and air
pump or air bag is
not installed
properly.
1. Change the hose or make it
unblocked, and check
whether the hose is cracked.
2. Reinstall the hose.
3. If the problem cannot be
solved, please contact with
the manufacturer or its
service agent or the similar
authorized personnel.
