www.SereneLifeHome.com
7
Cleaning and Storage
NOTE!
•
Before cleaning, read the safety instructions in the “Safety Instructions”chapter!
• Never immerse the device, or electrical cables in water or other liquids!
• Do not use any corrosive or abrasive cleaning agents or cleaning pads to clean
the device. These can damage the surface.
• Clean the device and the nylon balloon if necessary with a slightly damp cloth
and a little mild detergent if required. Then wipe down fully with a dry cloth.
• Allow all parts to dry completely before you put them away.
• Store the device in a clean, dry place that is protected from sunlight and is not
accessible to children and animals.
Troubleshooting
If the device does not work properly, check whether you are able to rectify the
problem yourself. If the problem cannot be solved with the steps that are listed.
Do not attempt to repair a defective electrical device yourself!
PROBLEM
POSSIBLE CAUSE / SOLUTION
The device does not
work. The LEDs do
not light up.
• Is the plug socket defective? Try another plug socket.
• Is the device switched on?
Set the timer knob (6) to a time.
Unusual noises
• Are the ventilation slots (5) covered up or blocked?
Free up the ventilation slots (5).
The device switches
off suddenly.
• Are the ventilation slots (5) covered up or blocked? Free
up the ventilation slots (5).
• The device has an automatic safety switch-off function.
It switches off automatically if it overheats. Allow the
device to cool down and switch it on again.
• Has the device fallen over? The device has a protective
switch that is activated if the device falls over. Set the
device up again and switch it back on.
Odor produced
• You might notice a slight odor caused by production
residues the first time you use the device. However, this
is harmless and will cease as you use the device.
Summary of Contents for SLIRX45
Page 10: ......
