9x
(b) Encryption keys removal from the ID transmitter
In order to remove encryption keys from the ID transmitter, it must be switched OFF.
Programming the ID transmitter into the main unit assigns unique encryption keys which encrypt the
communication between main unit and ID. After programming the ID transmitter, it can establish a
connection with only one main unit – the one with which it has been paired. This means that the ID
transmitter and the main unit are paired, i.e. they have encryption keys that define their connection.
In order
to program the ID transmitter into another main unit, you must remove the encryption keys from this
ID transmitter.
To perform this operation, enter the ID transmitter into settings mode (press the ID
transmitter button 9 times). Then enter the additional code 1-2-3-1. Entering of each digit is acknowledged
by the LED briefly going OFF and ON. After entering all 4 digits of additional code, press and hold the
button for the settings to take effect. After releasing the button, LED will blink rapidly if encryption keys
(encrypting communication with the previous main unit) were removed successfully.
It’s not possible to program one ID transmitter into two main units at the same time.
9x
(c) Removing (resetting) the previously set PIN code
To remove the previously set PIN code, press the ID transmitter button 9 times. The LED will light up and
the 1235
additional-code
should be entered. Entering of the additional code is performed by quickly
pressing the ID transmitter button adequate number of times for each digit. Entering of each digit is
acknowledged by the LED briefly going OFF and ON. After entering all 4 digits of the additional code, press
and hold the button until the LED goes OFF for the settings to take effect. After releasing the button, LED
will blink rapidly confirming that the previously set PIN code was removed. After performing this
procedure, check if it has been carried out correctly (check section 6x). It is also possible to remove the PIN
code using our mobile app available for iOS and Android.
FUNCTIONALITY IN DEVELOPMENT
9x
(d) Removing encryption keys from the main unit
All the ID transmitters you own must be switched ON and in range of the main unit during this
process.
In the case of losing one of the programmed ID transmitters or smartphones, remove it from the main unit.
It’s possible to remove ID’s as long as they are not within the range of the main unit when being deleted – to
do so, the user has to bring all the owned IDs and leave them switched ON and in range of the main unit – all
other IDs will be removed.
To delete all ID transmitters and smartphones which at the moment of removal will not be within the range
of the main unit, press the ID transmitter button 9 times. The LED will light up and the 1239
additional-
code
should be entered. To enter additional code quickly press the ID transmitter button respective number
of times for each digit. Entering of each digit is acknowledged by the LED briefly going OFF and ON. After
entering all 4 digits of the additional code, press and hold the button until the LED goes OFF for the settings
to take effect. After releasing the button, LED will blink rapidly confirming that all ID’s not present within
the range on the main unit at the moment of deleting, were removed. After performing this procedure, make
sure that it has been carried out correctly (check section 5x). It is also possible to remove a certain ID
transmitter using our mobile app available for iOS and Android.
FUNCTIONALITY IN
DEVELOPMENT
v 1.0 150219
