Disarming –
automatic while the ID transmitter is within the range of the main unit. If a PIN code is defined and you
do not have your ID transmitter with you, the immobilizer may be disarmed by entering the previously set buttons
combination. Single blink of dashboard indicator will confirm disarming of the immobilizer. The time between
pressing consecutive buttons must be shorter than 5 sec; in some vehicles this time must be longer than 0.4 sec.
Arming
– automatic 10 sec. after losing connection between the ID transmitter and the main unit. If a PIN code has
been set, switching the ignition OFF and opening driver’s door will arm the immobilizer (2 blinks of a dashboard
indicator)
Turning the ID transmitter ON or OFF
To switch the ID transmitter ON or OFF, press and hold the button for about 5 seconds. The LED will
indicate if it has been switched ON or OFF:
a)
5 blinks in about 2 seconds – the ID transmitter
has been switched ON,
b)
continuous light for about 2 seconds – the ID transmitter
has been switched OFF.
1x
Checking if the ID transmitter is switched ON or OFF
Press the button once to check if the ID transmitter is switched ON or OFF. The LED will indicate whether it
is switched ON or OFF:
a)
5 blinks in about 2 seconds – ID transmitter
is switched ON,
b)
continuous illumination for about 2 seconds – the ID transmitter
is switched OFF.
2x
Checking the status of the
service mode
The
service mode
allows to temporarily disable the immobilizer function and is useful while servicing the
vehicle. To check the status of the
service mode
(ON or OFF), the ID transmitter must be switched ON and
within the range of the main unit. Press the ID transmitter button twice and the LED will indicate the status
of the
service mode
:
a)
one blink –
service mode
is OFF (the immobilizer must be authorized to drive away),
b)
two blinks –
service mode
is ON (the vehicle is not protected by the immobilizer),
c)
no blinks – the ID transmitter not in range of main unit.
3x
Checking the connection status with the main unit and ID transmitter signal range
Pressing the ID transmitter button 3 times permits you to check whether the ID transmitter is programmed
into the main unit and if it is within its signal range.
a)
LED single blinks for 20 seconds – the ID transmitter is or has been programmed into the main unit,
but remains out of its range,
b)
LED double blinks for about 20 seconds – the ID transmitter is programmed into the main unit and is
within its range
. This information is useful when setting the desired signal range (see section 9).
Press the button 3 times again to extend the time of indicating whether the ID transmitter is within
signal range. NOTICE: signal range depends on the electromagnetic noise present in the surrounding
environment,
c)
three blinks – the ID transmitter has no encryption keys in its memory and can be programmed into
the main unit.
v 1.0 150219
