11
English
Bolting Down Your Safe
WARNING
DO NOT drill through bolt cups.
WARNING
DO NOT bolt through the walls.
WARNING
Do NOT drill from any location inside the safe.
Bolt down kit contents (in select models only):
2 lag screws
2 washers
2 masonry anchors
Tools needed to bolt safe to the floor:
Drill
Wrench
7⁄16" (11 mm) drill bit – for drilling into the safe
9⁄32" (7.2 mm) drill bit – for drilling into a wood loor
3⁄8" (9.5 mm) drill bit – for drilling into a masonry loor
1
Close the door. Tip the safe on to its left side (door hinges horizontal with the loor).
Look to the bottom of the safe for two indentations on the feet
in opposite corners. Using the 7⁄16" (11 mm) bit, drill a hole
through each indentation perpendicular to the bottom of the
safe.
DO NOT drill from any location inside the safe.
3
Tip the safe upright, place the safe in the desired location and open the door.
Use a screw or pencil to mark the loor through both holes.
For products that do not come with bolt down kits.
Go to
www.sentrysafe.com
to ind recommended hardware and instructions.
Bolt down instructions
2
4
