M6DXF2
P. / 4
EM-7848 Rev.
INSTALLATION
Set the unit so that its DIN rail adapter is at the bottom.
When the unit is installed to an Installation Base (model
M6DBS), refer to its instruction manual.
■
MOUNTING THE UNIT ON A DIN RAIL
A) Hang the upper hook at the rear side of unit on the DIN
rail.
B) Push in the lower in keeping pressing the unit to the
DIN rail.
■
REMOVING THE UNIT
A) Pull down the DIN rail adaptor using a minus screw-
driver.
B) Pull out the lower part of the unit.
C) Remove the upper part from the DIN rail.
TERMINAL CONNECTIONS
Connect the unit as in the diagram below or refer to the con-
nection diagram on the side of the unit.
DIN Rail
A
B
DIN Rail Adaptor
A
B
C
■
WIRING INSTRUCTIONS
• Applicable wire size
Solid:
0.2 to 2.5 mm
2
(0.55 to 1.75 dia.)
Stranded: 0.2 to 2.5 mm
2
(Tinning wire ends may
cause contact failure and therefore is not
recommended.)
Ferruled: 0.2 to 1.5 mm
2
(0.55 to 1.35 dia.)
• Expose wire conductors by 8 mm (0.31”).
How to Connect Wires
Insert a wire. Confirm that the wire tip hits the bottom and
tighten the screw with a screwdriver.
Confirm that the wire’s insulation tube is not caught in the
terminal.
8 mm
8 mm
3.7 mm dia.
max.
3.7 mm dia.
max.
Wire exposure
Recommended
ferruled wire
+
–
+
–
OUTPUT
5
6
7
8
POWER
1
2
3
4
CONFIGURATOR
JACK
+
–
INPUT 1
+
–
INPUT 2
POWER
CONNECTOR
Screwdriver
Wire
Screwdriver
Wire
8 mm
6 mm
Rugghölzli 2
CH - 5453 Busslingen
Tel. +41 (0)56 222 38 18
Fax +41 (0)56 222 10 12
www.sentronic.com
Produkte, Support und Service
SENTRONIC
AG
