WORLD OF WELLNESS
Installation instructions, only for experts
p. 30/50
●
The function selection switch
2
is set to the ON position as standard. Two-
sensor mode is therefore activated.
●
If you wish to deactivate single-sensor mode, place the function selection
switch
2
in the OFF position.
8.3. Activating/deactivating phase alignment
Phase alignment is activated or deactivated using the function selection switch
3
.
●
The function selection switch
3
is set to the ON position as standard. Phase
alignment is therefore activated.
●
If you wish to deactivate phase alignment, place the function selection switch
3
in the OFF position.
8.4. Activating/deactivating the remote start function
The remote start function is activated or deactivated using the function selection
switch
4
.
●
The function selection switch
4
is set to the OFF position as standard. The
remote start function is therefore deactivated.
●
If you wish to activate the remote start function, place the function selection
switch
4
in the ON position.
EN 60335-2-53 states that sauna control units with a remote start func-
tion may only be used with sauna heaters which satisfy the combustion
test described in paragraph 19.101 of EN 60335-2-53. Alternatively,
a suitable safety shut-off device can be installed in or above the heater.
Observe the information in the operating instructions for your sauna
heater.
!
