www.sentera.eu
MIW-MTX-EN-000 - 02 / 12 / 2015
7 - 7
back to the table of contents
OPERATING INSTRUCTIONS
The controller is to be used only with voltage controllable fans / motors. You can
connect several motors to the controller as long as the current limit is not exceeded.
The motor used should be protected internally against overheating.
The trimmer is adjusted so that the motor does not stop due to mains voltage
variations. The controller restarts after power failure.
In case of faulty operation
Please check if:
■
the right voltage is applied.
■
all connections are correct.
■
the machine to be regulated is functioning.
■
the fuse of the controller is OK.
In case that the fuse has blown up, remove the knob by turning it to the right, beyond
the end stop and then pull. Open the cover and unscrew the nut. Remove the fuse
holder with the help of a screwdriver. Replace the fuse. Mount all the parts back in
place.
ATTENTION
Use only fuses with type and rating specified above; otherwise, loss of warranty
will ensue.
TRANSPORT AND STOCK KEEPING INFORMATION
Avoid shocks and extreme conditions; stock in original packing.
WARRANTY INFORMATION AND RESTRICTIONS
Two years from the delivery date against defects in manufacturing. Any modifications
or alterations to the product after the date of publication relieve the manufacturer
of any responsibilities. The manufacturer bears no responsibility for any misprints or
mistakes in this data.
MAINTENANCE
In normal conditions this product is maintenance-free. If soiled, clean with a dry or
dampish cloth. In case of heavy pollution, clean with a non-aggressive product. In
these circumstances the unit should be disconnected from the supply. Pay attention
that no fluids enter the unit. Only reconnect it to the supply when it is completely dry.
MT
ELECTRONIC FAN SPEED
CONTROLLER
