www.sentera.eu
MIW-FCVC8-R-EN-000 - 28 / 08 / 2019
6 - 12
MOUNTING INSTRUCTIONS IN STEPS
Before you start mounting the unit, read carefully
“Safety and Precautions”
.
Then proceed with the following steps:
Inset mounting
1.
Disconnect the supply voltage.
2.
Remove the cover of the enclosure and take the controller out of the housing, so
that it can be easily connected.
3.
Do the wiring according to the wiring diagram (see
Fig. 1
).
Fig. 1 Wiring and connections
1
2
3
4
5
Power supply
85—264 VAC / 50—60 Hz
Modbus
RTU
/B
A
Analogue / modulating
output
4.
Mount the internal enclosure into the wall using appropriate connecting elements
(not included in the set). Mind the correct position and mounting dimensions
shown in
Fig. 2
and
Fig. 3
.
Fig. 2 Mounting dimensions - inset mounting
Fig. 3 Mounting position
38
15
58
82
82
89
76
58
58
52
Correct
Incorrect
Position at min. 1,5 m
from the floor
5.
Put back the frame cover of the enclosure.
6.
Switch on the power supply.
7.
Customise the factory settings to the desired ones via the 3SModbus software
or the Sensistant configurator. For the default factory settings, see
Modbus
register maps
below.
For surface mounting
1.
Disconnect the power supply.
2.
Remove the frame cover of the enclosure.
3.
Take out the internal enclosure.
FCVC8-R
INTELLIGENT MULTIFUNCTIONAL
FLUSH MOUNTED SENSOR