www.sentera.eu
MIW-MTP-D010-AT-BT-EN-000 - 06 / 02 / 2019
6 - 7
back to the table of contents
Fig. 2 Mounting dimensions - inset mounting
26
33
50x50
82
89
62
50
62
60
NOTE
Mount the unit so that the terminal block and connections are at the lower side.
5.
Adjust the Vmin and Vmax trimmers.
6.
Mount back the cover and secure it with the nut.
7.
Put back the knob and turn it to off position (-AT version) or minimum position
(-BT version).
8.
Turn on the power supply.
For surface mounting
1.
Remove the knob by turning it to the right until it pops out.
2.
Unscrew the nut to remove the cover of the external enclosure.
3.
Mount the external enclosure onto the surface by means of screws and dowels
(not included in the set) adhering to the mounting dimensions shown in
Fig. 3
Mounting dimensions - surface mounting
.
Fig. 3 Mounting dimensions - surface mounting
82
89
69
82
62
62
4.
Insert the cables through the grommets.
5.
Do the wiring according to the wiring diagram (see
Fig. 1
Wiring and connections
).
6.
Insert the internal enclosure into the external one and fix it using the screws and
washers included in the set.
NOTE
Mount the unit so that the terminal block and connections are at the lower side.
7.
Mount back the cover and secure it with the nut.
8.
Put back the knob and turn it to off position (-AT version) or minimum position
(-BT version).
9.
Turn on the power supply.
MTP-D010
ACTIVE
POTENTIOMETER
