System Setup
Downloading Readings from Probe
Copyright © 2008-2012 Sentek Pty Ltd All rights reserved
Page 11
b) Within the
Logger
tab press the “
Delete Readings”
button to delete any unwanted data that may
have been recorded before the probe was installed.
c) Within the
Sensor Test
tab check sensors are working and reporting values by selecting “
Query All
Sensors
”. When the probe is correctly configured and installed there should be no INVALID readings
for “Calibrated Value” of individual sensors (ignore the “Total” row).
d) Write to Probe (if required).
D
D
O
O
W
W
N
N
L
L
O
O
A
A
D
D
I
I
N
N
G
G
R
R
E
E
A
A
D
D
I
I
N
N
G
G
S
S
F
F
R
R
O
O
M
M
P
P
R
R
O
O
B
B
E
E
The data from the Sentek SOLO probe is downloaded in-field using either a Solo Download Cable to a laptop, or
the SoloPORTER.
Download Using Solo Download Cable
1. Unscrew the protective cap that sits atop the Sentek SOLO Head Unit
2. On the Solo Download Cable hold the section circled in red still and rotate the section circled in green to
release the protective cap from the Solo Download Cable
3. Plug in the Solo Download Cable by aligning the tab on the cable port with the notch on the Head Unit as
illustrated below. The pins on the serial connection should slide in firmly but smoothly, then twist the collar
clockwise (the collar is circled in green in the previous step) to secure the connection
4. To download make certain the other end of the field download cable is securely attached to you computer
COM port. (Computer without built in com ports will need a USB to serial adaptor)
5. Open Data Exchange.
