System Setup
Probe Configuration
Copyright © 2008-2012 Sentek Pty Ltd All rights reserved
Page 9
Figure 6: Clock tab
Logger tab
1. Select Logger tab and type in a Logger ID specific to the probe so that the data can be identified later. This
name is used to supply the IrriMAX database Logger ID. The default is the probe's serial number. The logger
ID can be up to 16 alpha-numeric characters and underscores and cannot contain any spaces.
2. Set your desired
Sample Origin
. This determines when the first reading will be taken by the interface. All
subsequent readings will use the Sample Origin as a starting reference. I.e. if the Sample Interval is 1 hour,
and the Sample Origin is midnight, but the probe is only switched on at 7:05am, the first reading will occur at
8:00am, then 9am, 10am etc.
3.
Last Response
: This is the result of the last attempt to upload to a SoloPORTER, see SoloPORTER
Hardware Manual for a description of the response codes.
4. Press the
Delete Readings
button to delete any unwanted data that may have been recorded
5.
Write to Probe
Figure 7: Logger tab
