CONTENTS
6
7
CONTENTS
Power & Volume Control
Plug the adapter of the provided 12V DC power cord into
the lighter of your vehicle, and plug the small connector
at the other end of the 12V DC power cord into the power
jack of your detector. This will send power to the detector
when your vehicle is running. To turn on the detector,
rotate the wheel controller (located on the side of the
detector) until you hear it click. To turn off the detector,
rotate the wheel controller in the opposite direction until
it clicks again. You can also use the controller to adjust
the volume level by turning it up or down within the
range that it does not click.
•
Opening Diagnosis:
The detector performs a single
loop of checking and demonstrating its audio, visual,
and voice alert capability for about 3~5 seconds each
time it is powered on.
•
Voice Preamble:
While the opening diagnosis is
running, the voice preamble lets you know which
user settings you used last. The user setting options
announced by voice preamble are:
- “
HIGHWAY1
” or “
HIGHWAY2
” or “
CITY1
” or “
CITY2
”
- “
BRIGHT
” or “
DIM
” or “
DIMMER
” or “
DARK
”
- “
VOICE ON
” or “
VOICE OFF”
One beep after the voice message of “
HIGHWAY
” means
Highway1, and two beeps after “
HIGHWAY
” means
Highway2. This is the same for City1 and City2 options
.
OPERATION
