Vision Viewer CE FA 45 GB - 068-14298 - 23.03.2010-00
Mounting and
operating instructions
24
2.2.2.1 Network connection with DHCP server
1. Click on: Start
Settings
Control Panel
Network and Dial Up Connections
Network connection (here
SMSC91181)
opens the following dialogue box ....
2. Select the option “Obtain an IP address via DHCP“.
3. Confirm with entries with OK.
4. After having changed the IP address, the Vision Viewer CE must be shut down with „Start“ and „Suspend“ in
order to save the settings.
2.2.2.2 Network connection without DHCP server
Contact administrator and request authorised IP addresses and settings etc. for Vision Viewer CE and if necessary
for FA45 Sensor.
To change over the Vision Viewer proceed as described in chapter 2.2.1 “Direct connection“.
To change over the sensor, proceed as described in chapter 2.2.1.2 in the mounting and operating instructions FA45
300 OB.
3.
Function
3.1
SensoView
In the SensoView module, it is possible to view
individual results, overall results and the sensor image
with marked detection zones (if “image transfer in run
mode” was set in SensoConfig).
The image can be enlarged with the Large Image but-
ton. The help button calls up help. Results and images
are displayed without any interruption of the sensor
and which thus does not require password entry.
SensoView can also be started for a pre-defined sen
-
sor immediately during boot-up of Viewer.
Fig. 9
155-01108
Summary of Contents for Vision Viewer CE
Page 39: ......