Sensopart Vision Viewer CE, Mounting And Operating Instructions, Page: 21 / 40

Vision Viewer CE FA 45 GB - 068-14298 - 23.03.2010-00
Mounting and
operating instructions
21
Passwords:
No password is required to start SensoView, as this does not interrupt the sensor’s run mode.
Uploading configurations or reading-out the recorder, if active, requires the user password, as these functions tem -
porarily interrupt the sensor’s run mode.
The default setting for the user password is “user”. This password can be modified in SensoFind / User Admin and
requires the administrator password. This is “admin” and can also be modified here. The “Sticky” option can be
selected so that password entry is only required once during a single session.
If an empty password is entered, the respective password is no longer requested.
It is possible to reset the password, should it e.g. be forgotten. This is carried out in the SensorFinder / SensoFinder-
Config.INI file under the rubric “password” by deleting the “User =“ and “Admin =“ entries.
Fig. 5
155-01106
Function:
Once the CE-Vision Viewer has been connected to the power supply, SensoFinder starts automatically. Provided the
Viewer is correctly connected, it will indicate which sensors are immediately available.
Fig. 6
155-01107
As the sensor has generally already been configured on a PC before use with the Vision Viewer, network settings
such as the sensor’s IP address, sub-net mask and DHCP should be correct. The sensor appears in the list in the
Finder and the IP address is shown in the “IP” column (1).
The “Local IP of PC“ box shows the current IP address of the Vision Viewer (2).
Activate the check box “Connect with restart” to ensure that the software for the appropriate sensor starts-up automa-
tically after switch-on.
(1)
(2)