Sensopart FA 46 301-CR, Mounting And Operating Instructions, Page: 22 / 50

FA 46 Vision Sensor GB - 068-14297 - 10.02.2011-05
Mounting and
operating instructions
67
4.3.1 Job
One job contains all the settings and parameters necessary for carrying out a specific inspection task.
Jobs can be created here and several jobs can be managed. All global settings, valid for the entire job, e.g. shutter
speed, amplification, illumination settings etc. are also carried out here.
The following basic image settings should first be carried out to ensure a high-contrast and sharp image:
* Image brightness: Set shutter time or amplification, see Job / General
* Image sharpness: Turn focus setting screw on the back of the FA 46 until the image is sharp.
The sensor is delivered with the following settings: Trigger Modus = „free run“ (see Job / General) and Trigger / colle-
ct image = „continuous“. A new image is thus continuously collected for focus and brightness settings and the display
is thus continuously updated.
The subsequent setting of position tracking and detectors should preferably be carried out in single image mode, as
all settings are then based on a master image and image collection is not continuously carried out. This may require
the following setting “ Trigger / collect image = “single image””.
Edit the job created as default job 1 in the list if necessary, and set the other basic parameters such as trigger mode,
internal / external lighting etc.
Position tracking and any number of different detectors can subsequently be defined within one job to solve an
inspection task.
Fig. 17
155-01207