RailPilot system manual
12
Once a connection is made, the following windows appear:
Here communication can be tested by holding an object less than 30 cm in front of the sensor; the distance
value displayed alters accordingly (only reflectors are detected beyond 30 cm).
Once a connection exists, all the protocol commands can be tested.
The following functions are available in the FR 85 ILLG
"
protocol tester
"
:
Input boxes for command
and parameters (command
in ASCII; parameters in hex)
Automatic setting of baudrate
for LJU control systems
FR 85-2 ILLG-S1L5
Displays the last strings sent
by FR 85 ILLG – S1L5; in
bytes in dec and hex
Automatic setting of baudrate
for DETO control systems
FR 85-2 ILLG-S1L5
Displays the last string sent
by the PC; in bytes in dec
Automatic delay of 300 µs
between the sensor receiving a
command and sending a reply
2.3 FR 85-2 ILLG – POL5
Switch points are programmed via PC.
RailPilot parameter software must be successfully installed on the appropriate device and a SensoPart
FR 85 set-up box is required.
The FR 85 setup box is connected to a PC via RS232 interface.
The
"
ProgSensor
"
Summary of Contents for 529-11008
Page 2: ...RailPilot system manual 1...