SensAlarm
Flex
–
Universal Gas Detection System
Sensidyne Document No. 360-0257-01 (Rev A)
P a g e
31 | 82
3. STARTUP
This section contains information necessary to perform the initial start-up of the SensAlarm Flex Universal
Gas Monitor. The magnetic screwdriver provided with your Gas Monitor will be required to perform these
steps.
3.1. Power On
3.1.1.
Before turning the unit on after Line Power has been terminated to the Power PCA, connect
the Positive Battery Lead if your Gas Monitor was purchased with Battery Backup.
3.1.2.
Once connected, move the rocker switch located at the top left hand of the enclosure to the
On (1) position.
3.1.3.
The Main Display will boot-up with a splash screen indicating the Main and Sensor
Interface(s) Firmware Revisions. This information is easily accessible after boot-up.
3.1.4.
After boot-up, the SensAlarm Flex Main Screen will be displayed. The Channel Information
located in the bottom left (single Sensor Interface) and / or bottom right (second Sensor
Interface) will in
dicate “Missing Sensor” in the Alarm / Fault Section.
Summary of Contents for SENSALARM FLEX
Page 1: ...Document No 360 0257 01 Rev A ...
Page 81: ......
