Sensi
TM
Wi-Fi Programmable Thermostat | INSTALLATION GUIDE
12
NOTES
Accessing account
information
You can use the Account area to access your email prefer-
ences, change your account information and email address
associated with your Sensi.
For iOS: Tap the person icon in the upper right hand corner.
(see picture)
For Android: Tap the three dots in the upper right hand corner.
HVAC configuration menu
If you chose the option “No, it needs to be installed” and
walked through the installation process on the Sensi app
the app should have correctly configured your thermostat for
your system type. You can check your system configurations
by accessing the “Menu” on the physical thermostat, and
then pressing “Set Up HVAC Equipment.”
Technical support
For problems connecting your Sensi thermostat, call or email
the Sensi Technical Support team, and they will be happy to
help you or your contractor walk through any steps needed
to troubleshoot the Sensi thermostat.
www.sensicomfort.com/support
(888) 605.7131
[email protected]
Menu item
Options
Outdoor Equipment
Configuration
AC1 Conventional Cooling 1
(Single Stage)
AC2
Conventional Cooling 2
(Two-Stage)
HP1 Heat Pump 1
(Single Stage)
HP2 Heat Pump 2
(Two-Stage)
ACO
No Cooling
Indoor Equipment
Configuration
For Gas or
Electric Heat
GA 1 Gas, oil, propane furnaces
or boilers
(Single Stage)
GA 2 Gas, oil, propane furnaces
or boilers
(Two Stage)
EL1
Electric furnaces
(Single Stage)
EL2
Electric furnaces
(Two-Stage)
FAN No Heating
Reversing Valve Position O
Heat pump
– O/B
is always energized
in Cool.
B
Heat pump
– O/B
is always energized
in Heat.
6
Zone valve setting.
* If you have a heat pump,
you’ll most likely have a
wire in O/B.
** If you have two stages,
you’ll have a wire in Y2.
* If you have two stages,
you’ll have a wire in W2.
* If you’ve installed your
Sensi Touch to a heat
pump, and your system
is producing warm air
in “Cool” and cool air in
“Heat,” you may need to
change your Reversing
valve position to either
O or B.
** There must be a wire in the O/B terminal for this configuration to affect
your HVAC system. If there is no wire in the O/B terminal, simply leave the
default setting as “O.”
