Strips MS-H Article #
1302002
Strips MS-WL Article #
1301002
User Manual
Joining Strips to your network
Strips comes in transport mode, when both of the magnets are attached the
device is idle. When removing the magnets for the first time, the device will
automatically send a join request.
*Tip : Make sure the device is set up on your server before removing the magnets
for the first time.
If you have removed the magnets, and you need to manually join the device, take
one of the magnets and move it to the round edge (Magnet sensor 2) of the Strip
3 times ( 3 green LED blinks at the Sensative logo ). This will send a join request to
the server. (See figure A)
One long green LED blink signals the device has been successfully joined to the
server
5 red blinks means the device failed to join to the network
Figure A)
After Strips is included in your network, the device is in default mode, and is only set
up as a magnetic contact sensor. In order to configure the device and turn on its
many functions, please see the Sensor Configuration instructions.
X3
Your devices key information can be found in
the package or sent to you digitally. Please
contact your Sensative representative to obtain
the key information via e-mail.
Magnet sensor 2
3.
