© 2020 Sensata Technologies
38
3.0 Setup
• TECH: 04 Load Defaults
– This menu restores all settings on the
inverter/charger, and any settings on accessories that are networked and
controlled by the inverter (i.e., ME-AGS-N) to the factory default settings.
To restore, press and hold the rotary SELECT knob for 5 seconds. Once
restored, the display will show
DEFAULTS LOADED
. The inverter/charger’s
factory defaults are listed in Table 3-5.
Note:
If a password (PIN) has been previously set, this menu will be
unavailable (i.e., locked). Refer to the TECH: 06 SETUP PIN section on the
next page for information on how to unlock this menu.
Info:
For information on the factory default settings for any
networked accessory, refer to the owner’s manual for that accessory.
TECH
Press
Status...
04 Load Defaults
Rotate to
Press and hold
for 5 seconds
Status...
DEFAULTS LOADED
Factory defaults
are loaded and
display shows:
Figure 3-25, TECH: 04 Load Defaults Selection
• TECH: 03 Inverter Model
– This read only menu displays the model
number of the connected inverter.
TECH
Press
Status...
03 Inv Model
Rotate to
Press
Status...
Model: ####
Display shows
connected inverter:
Figure 3-24, TECH: 03 Inv Model Display
Info:
When “
Model: UNKNOWN
” is displayed, the remote is unable
to determine the inverter model. This happens when the remote
is connected to a later/newer inverter model not recognized by an
older remote. All remote menu selections and features that are
available in the inverter will function normally.
Info:
The revision may display
“0.0”
for several reasons. Either the
inverter is not installed, there is no communication due to a bad/
miswired network cable, or the inverter is not powered or not working.
