SENOR TECH CO., LTD.
iSPOS User’s manual
28
5.6 Error Messages
Error Message
Possible Cause
C: drive error
Power off and reseat the hard disk drive. Run
CMOS setup utility and ensure the correct hard
disk type is entered (Auto Detect). If possible try
another known working hard drive in the iSPOS
If the new drive still does not work the problem
will be internal to the iSPOS, either the Hard
Disk "bay" is faulty or the motherboard is faulty.
If the replacement drive works, replace the
original drive and run DOS scandisk on the
drive, if the problem is not fixed, the drive is
faulty and will need to be replaced.
C: drive failure
Power off and reseat the hard disk drive. Run
CMOS setup utility and ensure the correct hard
disk type is entered (Auto Detect). If possible try
another known working hard drive in the iSPOS
If the new drive still doesn't work the problem
will be internal to the iSPOS, either the Hard
Disk "bay" is faulty or the motherboard is faulty.
If the replacement drive works, replace the
original drive and run DOS scandisk on the
drive, if the problem is not fixed, the drive is
faulty and will need to be replaced.
Keyboard error
Ensure the keyboard loopback plug and loop of
card reader connected properly
CMOS battery state low
Make sure the battery is working properly. Run
the CMOS Setup utility and enter the correct
parameters.
CMOS system options not set
Make sure the battery is working properly. Run
the CMOS Setup utility and enter the correct
parameters
CMOS display type mismatch
Make sure the battery is working properly. Run
the CMOS Setup utility and enter the correct
parameters.
