Tourguide 1039
| 11
Using the receiver
Using the receiver
To establish a transmission link between the configured transmitter and
receiver, proceed as follows:
1. Switch the receiver on (see next section).
2. Switch the transmitter on (see the instruction manual for the trans-
mitter).
The transmission link is established and the receiver’s RF signal indica-
tion
lights up green.
If you cannot establish a transmission link between transmitter and receiver,
read the chapter “If a problem occurs ...” on page 23.
Switching the diversity receiver on/off and
adjusting the volume
After switch-on, the receiver displays the standard display which allows the
user to switch between the receiving channels (see page 12).
You can configure the receiver via the Setup menu which you can access
using a special key combination during switch-on (see page 14).
To switch the receiver
on
:
왘
Turn the volume control
clockwise until it clicks.
The red LED
ON
lights up. The standard display appears on the display
panel.
To switch the receiver
off
:
왘
Turn the volume control
counterclockwise until it clicks.
The red LED
ON
goes off and the receiver switches off.
For information on how to configure the receiver, read the chapter
“Configuring the receiver” on page 14.
For information on how to configure the transmitter, read the chapter
“Configuring the transmitters for your Tourguide application” on
page 22 and the instruction manual for the transmitter used.
When not using the receiver for extended periods of time, remove
the accupack/batteries.
When you insert a switched-on receiver into the L 2015 charger, the
receiver automatically switches off. The receiver remains switched
off when you take it from the charger after charging. You first have
to turn the volume control
counterclockwise until it clicks to be
able to switch the receiver on (turn the volume control
clockwise
until it clicks).
Ch 4
English
