LSP 500 PRO
| 53
The operating menu
Detecting devices in the expansion slots
The Sennheiser devices of the ew 300 G3 and ew 500 G3 series feature a media
control protocol. The media control protocol sends, among other things, informa-
tion on the battery and mute status of the associated transmitters and on the
names of the individual devices to the app.
In order for the “LSP 500 PRO” tablet app (see page 23) to be able to display
this status information, the devices have to be detected once they are installed
in the LSP 500 PRO. Device detection has to be performed only once after instal-
lation of a device.
Device detection is only necessary if status information from the media
control protocol is to be displayed in the app. The devices installed in the
LSP 500 PRO also work properly if device detection is not performed.
To start the device detection process:
X
In the
SETTINGS
menu, turn the
MENU
jog dial until the
DEVICE DETECTION
menu item is displayed.
X
Press the
MENU
jog dial to open the
DEVICE DETECTION
menu item.
X
Switch the installed ew devices on before starting the device detection process.
In order to avoid possible conflicts with the media control protocol, it is
recommended to set the IP assignment mode of the installed ew G3 devices
to automatic. If the ew G3 device uses a fixed IP address, the IP address
must be in the range from 192.168.16.2 to 192.168.16.253 inclusive. For
more information, refer to the instruction manual of the ew G3 device.
X
Press the
MENU
jog dial to start the device detection process.
The device detection process is performed and the display panel displays the
slots in which a device with media control protocol has been detected.
When resetting the settings of the LSP 500 PRO (see page 54), the device
detection information is retained in memory.
Settings
Menu
Device Detection
