Statements regarding FCC and ISED
This device complies with Part 15 of the FCC rules, RSS-247 of Innovation, Science and Economic Development Canada (ISED). Operation is subject to the following two condi-
tions: 1) This device may not cause harmful interference, and 2) This device must accept any interference received, including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user
is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications made to this equipment not expressly approved by Sennheiser electronic Corp. may void FCC authorization to operate this equipment.
Déclaration requise par la FCC et ISDE
Cet appareil est conforme à la Partie 15 des réglementations de la FCC et aux normes CNR-247 d’Innovation, Sciences et Développement économique Canada (ISDE). L’utili-
sation de l’appareil doit respecter les deux conditions suivantes : (1) L’appareil ne doit pas produire d’interférences nuisibles, et, (2) il doit accepter toutes interférences reçues,
y compris celles qui pourraient avoir des effets non désirés sur son fonctionnement. CAN ICES-3(B)/NMB-3(B)
RF Radiation Exposure Information
The product complies with the rules of FCC and ISED (RSS-102) for the portable RF exposure limit set forth for an uncontrolled environment and is safe for intended operation
as described in this manual. This product is not subjected to FCC routine RF exposure evaluation per Section 2.1093 and RSS-102 of ISED. Further RF exposure reduction can
be achieved if the product can be kept as far as possible from the user body or set the device to lower output power if such function is available.
This transmitter must not be co-located or operated in conjunction with any other antenna or transmitter. Use of other accessories not verified by the manufacturer may not
ensure the compliance.
Informations sur l’exposition aux radiations RF
Le produit est conforme aux règles de la FCC et d’ISDE (CNR-102) en ce qui concerne la limite d’exposition portable RF définie pour un environnement non contrôlé et est sans
danger pour le fonctionnement prévu, tel que décrit dans ce manuel. Ce produit n’est pas soumis à l’évaluation de routine de l’exposition aux RF par la FCC conformément à la
section 2.1093 et à la norme CNR-102 d’ISDE. Une réduction supplémentaire de l’exposition aux RF peut être obtenue si le produit peut être maintenu aussi loin que possible
du corps de l’utilisateur ou si l’appareil est réglé sur une puissance de sortie inférieure, si cette fonction est disponible.
Cet émetteur ne doit pas être installé ou utilisé en conjonction avec une autre antenne ou un autre émetteur. L’utilisation d’autres accessoires non vérifiés par le fabricant ne
peut pas garantir la conformité.
Taiwan
經型式認證合格之低功率射頻電機,非經許可,公司、商號或使用者均不得擅自變更頻率、加大功率或變更原設計之特性及功能。
低功率射頻電機之使用不得影響飛航安全及干擾合法通信;經發現有干擾現象時,應立即停用,並改善至無干擾時方得繼續使用。前項合法通信,指依電信法規定作業之
無線電通信。低功率射頻電機須忍受合法通信或工業、科學及醫療用電波輻射性電機設備之干擾。
9LӋWQDP
.ӇWӯQJj\WKiQJQăPFiFVҧQSKҭPÿѭӧFVҧQ[XҩWEӣL6HQQKHLVHUWXkQWKӫ7K{QJWѭ77%&7TX\ÿӏQKYӅJLӟLKҥQFKRSKpSÿӕLYӟLPӝW
VӕFKҩWÿӝFKҥLWURQJFiFVҧQSKҭPÿLӋQYjÿLӋQWӱ