19
If a problem occurs ...
If a problem occurs ...
If a problem occurs that is not listed in the above table or if the problem
cannot be solved with the proposed solutions, please contact your local
Sennheiser partner for assistance.
To find a Sennheiser partner in your country, search at
www.sennheiser.com under “Service & Support”.
Problem
Possible cause
Possible solution
Plug-on transmitter
cannot be operated,
“
Locked
” appears on
the display panel
Lock mode is
activated
Deactivate the lock mode
(see page 8).
No operation
indication
Batteries are flat or
accupack is flat
Replace the batteries or
recharge the accupack
(see page 6).
No RF signal at the
receiver
Plug-on
transmitter and
receiver are not on
the same channel
Set the plug-on
transmitter to the same
channel as the receiver.
Synchronize the plug-on
transmitter with the
receiver (see page 17).
Transmission range
is exceeded
Reduce the distance
between plug-on
transmitter and receiving
antennas.
RF signal is
deactivated
(“
RF Mute
“)
Activate the RF signal
(see page 8).
RF signal available,
no audio signal,
“
MUTE
” appears on
the display panel
Plug-on
transmitter is
muted (
MUTE
)
Cancel the muting
(see page 8).
Receiver’s squelch
threshold is
adjusted too high
Reduce the squelch
threshold setting on the
receiver.
Plug-on
transmitter doesn’t
transmit a pilot
tone
Activate the pilot tone
transmission
(see page 16).
Audio signal has a
high level of
background noise or
audio signal is
distorted
Plug-on
transmitter’s
sensitivity is
adjusted too low/
too high
Adjust the input
sensitivity (see page 13).
Summary of Contents for EM 300 G3 - 01-09
Page 1: ...SKP 100 Instruction manual...