![background image](http://html1.mh-extra.com/html/sennheiser/ek-6042/ek-6042_instruction-manual_1242690019.webp)
EK 6042
| 19
Using the EK 6042
settings in the
Transmitter
,
Frequency
and
Squelch
submenus.
Then,
Hold to IR
appears again on the dis-
play panel and the infra-red interface
flashes blue again.
왘
Hold the infra-red interface of the transmitter in front of the infra-red
interface of the EK 6042.
The determined frequency is transferred to the transmitter. If the
transfer was successful, the status LED of the corresponding receiving
channel lights up green – provided that the transmitter is not muted.
The radio link is ready for immediate use. If the transfer fails, the mes-
sage
Failure
appears on the display panel.
Performing a frequency scan
You can perform a frequency scan to get an idea of the current frequency
situation on site. During a frequency scan, the audio outputs of both
receiving channels are muted.
왘
Call up the operating menu (see page 15), select
Spectrum Scan
and
confirm the warning message.
The frequency scan starts from the center of the EK 6042 frequency
range and scans simultaneously toward the lower and higher frequen-
cies. You can use the
and
buttons to scroll through the entire
frequency scan at any time.
왘
Press the
button to return to the operating menu.
Changing scenes
If microphones are changed between several takes and there is no time
for configuring the devices, you can prepare as follows:
왘
Configure the transmitter and the EK 6042 in advance. Store each of the
required receiver configurations as a scene (see below).
You can store up to 10 scenes.
왘
Change to the required configuration without losing time by calling up
the stored scene (see page 20).
Storing a scene
왘
Set all parameters as desired and synchronize the corresponding
transmitters.
To set a receiving frequency, you can use the functions in the
Frequency
submenu of the
CH1 Settings
and
CH2 Settings
menus (see page 16). Alternatively, you can perform an auto-
matic configuration (see page 17).