![background image](http://html1.mh-extra.com/html/sennheiser/504302/504302_instruction-manual_1241130024.webp)
23
Using the headset system
Switching the headset on/off
Switching the headset on
왘
Press and hold the LINK button
The HEADSET LED
flashes blue 3 times and the wireless link to the
base station is established (where required). An ascending confirma-
tion beep is heard in the headset.
Switching the headset off
왘
Press and hold the LINK button
The HEADSET LED
Establishing a wireless link between headset and
base station
To establish a wireless link between headset and base station:
왘
Press the LINK button
The link is established. The LINK LED
lights up blue and the
flashes blue.
To disconnect a wireless link between headset and base station:
왘
Press the LINK button
The link is disconnected. The LINK LED
and the HEADSET LED
off.
If you place the headset into the base station, the headset automat-
ically switches to standby mode. In standby mode, the power
consumption is very low and the radiated power is reduced to a
minimum. The HEADSET LED
lights up blue and the rechargeable
battery is being charged.
4 3
4 3
You can also establish or disconnect the wireless link by pressing
the PC button
or the PHONE button
on the base station
(depending on the selected mode (
PC
or
Phone
), see page 28).
If your telephone has a built-in electronic hook switch supporting
the MSH standard (see page 13), you can only disconnect the wire-
less link between headset and base station by placing the headset
into the base station. The control signals (“accept a call”, “end a
call”) of the headset are still transmitted to the electronic hook
switch without.