SCT-1024 Ver. 2.3
7
OPERATION
The Pelco Pan, Tilt, Zoom, Focus, and Iris commands are converted to the equivalent Vicon
commands. Other commands are converted according to the following table.
PELCO COMMAND
VICON COMMAND
[Aux][1][On]
Aux
(If Momentary Aux switch is ON, simulates pressing and releasing Aux key.)
[Aux][2][On]
A/P
[Aux][3][On]
A/I
[Aux][4][On]
Alarm Acknowledge
[Aux][5][On]
L/S
(Note: Sending [Aux][Off] will send the Vicon stop command.)
[Aux][6][On]/[Off]
Activate/Deactivate slow speed mode
(In slow speed mode, the code translator divides all pan and tilt
speeds by two. Power-up default is deactivated.)
Preset 1~99
Run Preset 1~99
Pgm Preset 1~99
Pgm Preset 1~99
Here is a listing of Vicon Dome functions for presets 80~99.
Pgm Pattern 1 or Pgm Preset 88
Pgm Auto Tour 88
Pgm Pattern 2 or Pgm Preset 89
Pgm Auto Tour 89
Pattern 1 or Preset 88
Run Auto Tour 88
Pattern 2 or Preset 89
Run Auto Tour 89
Pgm Preset 90
Lock / Unlock Pan & Tilt
Pgm Preset 94 or Pgm Preset 95
Activate On-screen Menu
(Use joystick to navigate, [Aux][2] (A/P) to select, and [Aux][3] (A/I) to exit.)
Pgm Preset 96
Soft reset - Autobaud detect
Pgm Preset 98
Set Autopan Left Limit
Pgm Preset 99
Set Autopan Right Limit
Pgm Preset 97
Set Autopan Speed
(After sending this command, deflect the joystick in a pan direction. This will activate autopan and
the speed will change with joystick deflection. When the desired autopan speed is reached, press
any lens key. Then release the joystick and the dome will continue to autopan at that speed.)
Summary of Contents for SCT-1024
Page 2: ...2...
