18
7.1.4 Certification Tab
Calibration certificate can be issued based on the latest calibration data. Latest
calibration data will be stored on the USB Disk and can be printed using Docking
Manager software. The certi file name will be created for each device by their
Serial numbers and will be in “.csv” format.
Note:
USB drive must be installed to store the test results.
By connecting USB Disk, “Certification” Tab is not available on software interface.
Click “Refresh” button to view and print the calibration certificate.(only can print latest
calibration data)
After clicking “Refresh” button, all data will be available to view (see Figure 9).
To print latest calibration certificate, follow the below:
✓
Plug the IR Link into a USB port on PC and place into Bay Unit 1.
✓
Double click and open the installed software.
✓
Click “OPEN” button at the top right corner of the software interface.
✓
Click “Certification” Tab and Click “Refresh” button.
✓
Select needed device by indicating devices serial number in Certi File Name
section.
✓
Click “Load” button and information will be shown automatically in the right
side.
✓
Select address section between Senko, Senko Canada, Senko EU, No address.
✓
Write the authorized person’s name in the “Calibrated by” & “Approved by”
✓
Click “Print” button to print the calibration certificate.
✓
When printing is finished, “success” message will come up.
Figure 9
MGT Docking Station version II