ENGLISH 6/7
9 PURCHASE ORDER CODES
CODE
DESCRIPTION
Z-PC-DINAL1-35
DIN rail support with screw terminals P= 35 mm
Z-PC-DINAL2-17,5
DIN rail support with screw terminals P= 17.5 mm
Z-PC-DIN1-35
DIN rail with one slot support for rear connector P= 35 mm
Z-PC-DIN2-17,5
DIN rail with two slots support for rear connector P= 17,5 mm
Z-PC-DIN4-35
DIN rail with four slots support for rear connector P= 35 mm
Z-PC-DIN8-17,5
DIN rail with eight slots support for rear connector P= 17,5 mm
CE-RJ45-RJ45-R
Ethernet cable 1,5 m
7 CONFIGURATIONS
SW1 DIP-switches configuration to load factory settings
This procedure returns the IP address to the factory default: 192.168.90.101 and return
the credentials for access to the web server to: User= admin and password= admin.
SW1 KEY
Turn off the Z-TWS11 module and set to
ON
all eight DIP switches SW1.
Turn on the Z- TWS11 module and then wait 10 seconds.
Turn off the Z- TWS11 module and set to
OFF
all eight DIP switches SW1.
ON
1
OFF
0
SW2 Switch setting
RS232 or RS485 configuration on terminals 10-11-12 (serial port COM 4)
SW2 KEY
RS232
ON
1
RS485
OFF
0
8 LED SIGNALING ON THE FRONTAL PANEL
LED
STATUS
LEDs meaning
Tx1 Red
Blinking
Data transmission activity on COM4
OFF
No data transmitting on COM4
Rx1 Red
Blinking
Data reception activity on COM4
OFF
No data receiving on COM4
Tx2 Red
Blinking
Data transmission activity on COM2
OFF
No data transmitting on COM2
Rx2 Red
Blinking
Data reception activity on COM2
OFF
No data receiving on COM2
Tx1+Rx1+Tx2+Rx2
Blinking
PLC program not
present
PWR Green
ON
Z-TWS11 ON
OFF
Z-TWS11 OFF
SD Red
Blinking
Micro SD card access
ETH LNK Green
Blinking
RJ45 connection activated
ETH ACT Yellow
Blinking
Traffic on Ethernet port
MI00367
-3
-E
